Changing The Air Filter; Troubleshooting - ResMed Tango C Serie Guia Del Usuario

Changing the Air Filter

CAUTION
Do not wash the air filter.
With the power cord and air tubing disconnected, turn the Tango upside down so the
1.
air inlet is facing you. The air filter is inside the air inlet.
Pull the old air filter out of the air inlet.
2.
3. Put the new air filter into the air inlet in the direction shown by the arrow, with the
blue side facing towards you.

Troubleshooting

Problem
Tango won't start
No/low air flow
Treatment pressure
seems either low or too
high
LCD displays an error
message and treatment
stops or can't be started
Air inlet
Air filter
Possible Cause
Power cord not connected
properly.
Faulty power outlet.
The air tubing is not connected
properly.
The air tubing is blocked,
pinched or punctured.
Altitude setting incorrect.
Problem with motor.
Solution
Check power cord.
Try another power outlet.
Adjust the air tubing connection.
Unblock or free the air tubing. Check the
air tubing for punctures.
Adjust altitude setting.
Contact your supplier.
5