Publicidad
Idiomas disponibles
Idiomas disponibles
u h f - 5 1 0 0
s i n g l e u h f
w i r e l e s s s y s t e M
The UHF-5100 single channel UHF series wireless system is a high qual-
ity audio product that provides excellent performance under most op-
erating conditions and allows for automatic or manual frequency ad-
justment.
Two different versions are available and operate on different ranges of
UHF frequencies between either 669.075 MHz to 697.95 MHz (US ver-
sion) and 836.075 MHz to 864.95 MHz (EURO version).
THE MODELS AVAILABLE ARE:
UHF-5100M - Which comes equipped with a handheld microphone
transmitter.
UHF-5100HL - Which comes equipped with a belt pack transmitter
and Headset/ lavalier combo.
o p e r a t i n g t h e u n i t
1.
Remove all packing materials. Save the box and packing materials
to transport the unit and in case the unit ever requires service.
2. Plug the AC/DC adaptor into the rear of the receiver (12). Then plug
the adaptor into an appropriate AC Outlet. Push the Power On (2)
button to turn the unit on. The LCD display will be illuminated.
3. Extend the antenna (1) fully vertical and point it out into the direc-
tion you will be speaking from.
4. Insert an XLR or 1/4" cable into the XLR jack (9) or 1/4" jack (10) on
the rear of the receiver and connect the other end of the cable to
your amp, effects or mixer jack.
5. Enter the menu by pressing the Menu Control (4) and toggle be-
tween the Automatic Channel Selection or Manual adjustment by
pressing the Menu Control.
FOR AUTOMATIC CHANNEL SELECTION:
1. Press MENU once. The LCD display (7) will show AUTO-
MATIC and flash.
2. Press SELECT (5), receiver start to scan clear channel and
stop.
14
U H F - 5 0 0 0
s e r i e s m a n U a l
•
g e m i n i d j
FOR MANUAL SETTING:
1. Press menu twice. The LCD display (7) will show GROUP
and flash.
2. Press SELECT (5) to increase group one by one from 0 to
33. Press and hold to search through groups faster.
3. After setting the group, press SYNC (6) to escape, or wait
5 seconds to escape automatically.
4. Press menu 3 times. The LCD display will show CHAN-
NEL and flash. Press SELECT repeatedly to increase chan-
nel one by one. From 0 to 33. Press and hold to search
through channels faster.
5. After setting the channel, press SYNC to escape, or wait 5
seconds to escape automatically.
6. After setting the channel control, press SELECT to display
existing channel frequency.
6. Adjust the volume using the level control (3) on the front panel. You
can also use the Line/Mic Gain switch (11) to toggle between a mic-
level signal and line-level signal.
Note: Effective range between the transmitter and receiver is up to 250
feet.
.
U H F - 5 0 0 0
c o m
s e r i e s m a n U a l
.
•
g e m i n i d j
c o m
15
Publicidad
