Balanced Body Rialto Reformer Manual Del Usuario página 23

4. Now, install the set screws from Step 2 into the middle hole in
each leg using the 5/32" Allen wrench. Tighten the two set
screws in each leg. See Figure C.
Fig C
5. Your tower is now ready to use. Please make sure to read and
follow all the safety procedures.
OPTION: INSTALLING THE TWIN MATS
1. Move the spring bar to the last gear. This is the position
closest to the foot end of the reformer.
2. Attach at least one spring from the carriage to the spring bar.
3. Move the footbar to the flat or zero degree position in the
trunnions.
4. Remove the shoulder rests from the carriage.
5. Place the contoured mat conversion on the head end of the
reformer. Place the rectangular mat over the carriage on the
foot end of the reformer.
Tighten top two set
screws on both legs.
21