Maintenance - Powermate PFTT142.1 Manual De Operación

Maintenance

• Save all instructions
A
Maintenance Schedule
WARNING
Before performing any maintenance, turn engine off and remove the wire from the spark plug to prevent accidental starting
and serious injury .
IMPORTANT: The warranty on this tiller does not cover items that have been subjected to operator abuse or negligence. To receive
full value from the warranty, the operator must maintain the tiller as instructed in this manual, and only use genuine replacement
parts. The following table lists required periodic maintenance.
PERIODIC MAINTENANCE SCHEDULE TABLE
Service Records-
Fill in dates as you complete regular
service
Check Engine Oil Level,
Fill to Proper Level
Clean Debris From Unit
Lubricate All Pivot Points
Check Fasteners for Tightness
Check Drive Belts
Replace if Necessary
Check Tines for Wear or Damage
Replace if Necessary
Check Fuel Line
Replace if Necessary
Lubricate Wheel Axles
Check Spark Plug
Replace if Necessary
Change Engine Oil
Clean Air Filter
Replace if Necessary
Replace Spark Plug
Clean Combustion Deposits from
Cylinder, Piston, and Valves
CAUTION
IMPORTANT NOTES about Maintenance schedule
1 . Re-check tightness of all fasteners after first 2 hours of initial use
2 . Change engine oil after first 5-8 hours of initial use
3 . Change oil every 25 hours
4 . Clean air filter every 10 hours if operating under dusty conditions .
WARNING
Use only GENUINE replacement parts . Other parts may damage the unit or result in injury .
Questions? Call Toll Free at 1-800-737-2112
After After
Before Every Every
Each Use 10 Hours 25 Hours of
of Use Use
√
√
√
√
√
√
ENG - 16
After
After Every
Every
50 Hours of
100 Hour
Use
of Use
√
√
√
√
√ √
√ √
√
Copyright © 2018 MAT Engine Technologies, LLC
Before See
Before
Each Note
Storage
Season Below
√
√ √
√ √
√
1
√
√
√
√ √
√
√ √
2,3
√
4