Menu Button; Channel Selection; Ctcss/Dcs Tones Selection - Midland G7 Pro Manual Del Usuario

MENU button

Channel selection

Press once the MENU button. The number of the channel will start
flashing on the display. Press the scroll buttons / to scroll up or down
the PMR and then LPD channels till you select the desired channel.
Press the PTT button to confirm, or wait for 10 seconds.
Refer to the table of frequencies.

CTCSS/DCS tones selection

Midland G7/G7E Pro can receive in two modes:
a. Open traffic: in this case you will hear any communication transmit-
ted on the selected channel;
b. Group mode CTCSS/DCS: CTCSS/DCS tones are access keys that
allow you to receive only messages coming from parties using the
same channel and code. The speaker will remain muted until the
correct tone is received.
To activate 1 of 38 different CTCSS/104 DCS tones in RX and TX
1. Turn on the radio.
2. Select the desired channel.
3. Press twice MENU until the Display shows oF.
4. By pushing the /
king) or DCS (dc blinking); press MENU to enter the CTCSS or DCS
tones. Now select the desired tone with the
5. To confirm the setting, press the PTT key or wait for approximately
10 seconds.
Midland G7 Pro user's manual
controls the display will show CTCSS (ct blin-
/ keys.
| 17