Administration > Factory Defaults; Administration > Upgrade Firmware; Administration > Config Management - Cisco LINKSYS WRT54G2 Guia Del Usuario

Chapter 3
Ping Test
Traceroute Test
Traceroute
To test the performance of a connection,
click Traceroute to open the Traceroute Test screen. Enter
the address of the PC whose connection you wish to test
and click Traceroute. The Traceroute Test screen will show
if the test was successful. To stop the test, click Stop. Click
Clear Log to clear the screen. Click Close to return to the
Diagnostics screen.
Traceroute Test
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router's configuration to its factory default
settings.
Factory Defaults
Restore Factory Defaults
to the default values, select Yes, and then click Save
Settings. Any settings you have saved will be lost when
the default settings are restored.
Administration > Factory Defaults
Wireless-G Broadband Router
To reset the Router's settings
Advanced Configuration
Administration > Upgrade Firmware
The Administration > Upgrade Firmware screen allows
you to upgrade the Router's firmware. Do not upgrade
the firmware unless you are experiencing problems with
the Router or the new firmware has a feature you want
to use.
Administration > Upgrade Firmware
Before upgrading the firmware, download the Router's
firmware upgrade file from the Linksys website,
www.linksysbycisco.com.
Upgrade Firmware
Please select a file to upgrade
the firmware upgrade file. Then click Upgrade and follow
the on-screen instructions.
Administration > Config Management
This screen is used to back up or restore the Router's
configuration file.
Administration > Config Management
Backup Configuration
To back up the Router's configuration file, click Backup.
Then follow the on-screen instructions.
Click Browse and select
21