Back Panel - Peavey kosmos RATTLE YOUR PLANET Guia De Funcionamiento

6. THUD:
This control adds a specific band of bass frequencies (natural, not synthesized) to the sub
harmonics generated by the QUAKE process. It is tuned roughly an octave above the sub
harmonics and is used to even out the low-end balance.
7. XPANSE:
This is a combination control, simultaneously adjusting high-frequency boost and stereo
width. The minimum position is the flat setting. As the control is rotated clockwise, the
left/right image becomes wider and clarity is increased. This feature is designed to pull vocals
more to the front of the mix while giving them a 3-dimensional quality. Power chords played
on guitar benefit as well.
8. SUB WOOFER:
Built into the kosmos
the QUAKE output, the THUD output, and the low frequencies from the 90 Hz crossover
network. This control sets the output level.
9. POWER:
This switch applies AC mains power to the internal power supply. When the unit is
functioning, the blue power LED will illuminate. AC power is required even in bypass mode,
since the unit has built-in active level shifting capabilities.

BACK PANEL

10
10. IEC CONNECTOR:
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug
and ratings for the intended operating voltage is included. The mains cord should be
connected to the unit before connecting to a suitable AC outlet.
U.S DOMESTIC AC MAINS CORD
The mains cord supplied with the unit is a heavy-duty, 3-conductor type with a conventional
120 VAC plug with ground pin. If the outlet used does not have a ground pin, a suitable
grounding adapter should be used, and the third wire should be grounded properly.
Never break off the ground pin on any equipment. It is provided for your safety.
is a 90 Hz subwoofer crossover. The subwoofer signal is the sum of
™
11
12
5
13