General Operation; Powering The Unit On/Off; Using The Pmr; Speaking To Other Radio - Albrecht Tectalk FM+ Manual Del Usuario

Radio pmr con radio fm
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General Operation

Power On/Off
To switch on, press "
Channel no. and battery level icon.
To switch off, press "
turns off.
Using the PMR446 radio part for communication
The unit has 8 main channels & 38 CTCSS codes. You can
communicate with any other PMR446 radio that is using the same main
channel & CTCSS code.
Speaking to other radios
Press & hold the PTT key, the RED LCD Backlight will turn on &
show
icon.
Hold the unit in a vertical position with the Microphone 5-8cm
from the mouth and then speak with normal voice.
When you have finished speaking, release the PTT key and you
will hear a beep tone.
Listening to other radios
The radio will automatically play received transmissions.
While you press the PTT key, you cannot listen to other radios.
Adjust volume control if necessary.
" Key, the LCD display shows the
" Key for 2 seconds until LCD display
Using an external Microphone/Earphone set
Plug the external mic / earphone set into the headset socket.
Press and hold the PTT button on the earphone to speak.
Release the PTT key to listen.
Adjust volume control if necessary.
Make sure that – if equipped- the mode switch at the
Mic/Earphone set is on "PTT" position.

Adjusting speaker volume (15 Levels)

In PMR 446 mode, just press the
Press the
key to decrease the volume.
In FM broadcast mode, these keys normally adjust the receiving
frequencies. To use the keys for volume up/down, please press
first
to switch over to volume setting!
TX Time Out Function
TX time out function can avoid accidental transmission and
prolong the battery life.
The unit will stop transmitting and sound a warning tone when
PTT is hold over 60 seconds. You then need to release PTT and
press it again for further transmission.
key to increase the volume.
21

Publicidad

Tabla de contenido
loading

Tabla de contenido