Dmx Linking - Chauvet DJ Cumulus Guía De Referencia Rápida

Operation
1. Place the machine on a level surface. Plug the power cord into the wall.
2. Remove the top lid.
3. Fill the water tank with distilled water to the maximum fill line located on the inside of the tank. The container can
hold up to 2 gal or (7.6 l).
4. Fill the fluid tank with CHAUVET haze or fog fluid to the maximum fill line located on the outside of the tank. The
container can hold up to 0.9 gal (3.25 l).
5. Turn the product on using the power switch on the back panel. Make sure the fans are operating properly.
6. Using the control panel, set the product to the desired operating mode.
• Due to water evaporation, you may need to refill the Cumulus with water to
continue triggering the machine.
• The Cumulus is fitted with a safety shutoff feature, which prevents the unit's
heaters from turning on when the water level is too low. If this safety shutoff
feature has been engaged, simply add more water to continue using the
Cumulus.
The Cumulus can operate with the top lid on or off.

DMX Linking

The Cumulus can work with a DMX controller. Instructions for connecting and configuring this product for DMX operation
are in the User Manual. If you are not familiar with DMX, download the DMX Primer from www.chauvetdj.com.
Starting Address
To ensure full access to all channels available in DMX mode, the highest recommended DMX address is 512.
DMX Values
2-CH
CHANNEL FUNCTION
1 Fan Speed
2 Fog Output
Cumulus QRG Rev. 4
QUICK REFERENCE GUIDE
VALUE PERCENT/SETTING
000 010 No function

011 512 1–100%

000 010 No function

011 512 1–100%

EN
4