Assembly; Assembling The Heater; Connecting To Gas Supply; Theory Of Operation - Mi-T-M MH-0080-CM10 Manual Del Usuario

ASSEMBLING THE HEATER

1. Remove heater from carton
2. Slide upper housing straight up and off of lower housing, and remove all
of the packed items from inside heater.
3. Remove all packaging protecting heater during shipping. Retain plastic
caps covering inlet and regulator hose for storage
4. Save carton and packing materials for later storage.
5. Inspect heater closely for any damage that may have occurred during
shipping. If there is any damage, return the heater to the place of
purchase.
6. Attach 4 (four) of the phillips head screws to the bottom row of holes in
the lower housing.
7. Slide upper housing over lower housing, lining up the four remaining screw
holes. Insert 4 (four) phillips head screws and tighten securely.
Support Screws
in place
WANRING: NEVER ATTEMPT TO LIGHT A HEATER UNTIL IT
IS FULLY ASSEMBLED.

CONNECTING TO GAS SUPPLY

IMPORTANT! Always use a propane cylinder that has a connection
device that is compatible with the hose and regulator assembly
supplied.
1. To connect hose and regulator assembly, rotate fitting on hose/
regulator COUNTERCLOCKWISE into threads on tank valve (see
Figure 5). Be sure to tighten firmly.
Important: Be sure to position the regulator so that the regulator is horizon-
tal, also as shown .
2. To connect to heater inlet, rotate clockwise and tighten firmly
with a wrench.
3. Check all connections for leaks, using a 50/50 solution of dishsoap
and water. Bubbles at the connections show a leak. Correct all
leaks before lighting heater. NEVER USE AN OPEN FLAME TO
CHECK FOR LEAKS.

THEORY OF OPERATION

Fuel Supply System Fuel is supplied under pressure from the
fuel cylinder to the heater by the hose/regulator assembly. The regulator maintains a constant flow of fuel
to the heater.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
Propane Convection Heater Manual

ASSEMBLY

Phillips screws
Upper Shell
Phillips Screws
(use bottom holes)
Supply Valve
Regulator
Hose
Connector
Inlet
Regulator Hose
Assembly
Phillips and Support
Screws, Knob
Lower Shell
Gas Valve Stem
Propane Tank
Hose
11