Assembly; Unpacking And Assembly; Ventilation; Connecting To Gas Supply - Mi-T-M Outdoor MH-0018-0D10 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACKING AND ASSEMBLY

1. Remove heater and base from Carton (Save carton and packing materials for later storage).
2. Remove all protective packaging protecting heater during shipping.
3. Place Heater Base on flat surface with wheels
on ground.
4. Line up holes in bottom of heater cabinet with
locking tabs on top of base.
5. Mount heater cabinet to heater base sliding
tabs through holes in bottom of cabinet and
sliding cabinet backward approximately ¼" or
until cabinet will not move further back.
6. Use thumbscrews to attached heater cabinet
to heater base.
7. Inspect heater closely for any damage that
may have occurred during shipping. If there is
any damage, return the heater to the place of
purchase.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
WARNING: THIS HEATER IS NOT INTENDED FOR RESIDENTIAL USE.

VENTILATION

Caution: Always provide a fresh air opening in the heated space of at least three square feet (2,800 sq. cm)
for each 100,000 BTU/Hr. of heater output. Provide a larger opening if more heaters are being used. As an
example, a MH-0018-0D10 heater will require:
a two-car garage door open 2 inches, or
a single car garage open 3 inches, or
two thirty two inch wide windows open 4 inches

CONNECTING TO GAS SUPPLY

CAUTION: THE PROPANE (LP) GAS PRESSURE REGULATOR AND HOSE ASSEMBLY SUPPLIED
WITH THE HEATER MUST BE USED WITHOUT ALTERATION.
CAUTION: BE SURE TO INSPECT THE REGULATOR HOSE BEFORE EACH USE. IF THE HOSE IS
CUT OR FRAYED, REPLACE IT WITH THE MANUFACTURER SUGGESTED ASSEMBLY.
IMPORTANT! Always use a propane (LP) cylinder that has a connection device that is compatible with the
hose and regulator assembly supplied.
1. Remove the Back Cover by sliding the cover straight up
and away from the Heater Body. Place the LP cylinder on
the Bottom Plate and replace the Back Cover.
2. To connect LP cylinder, insert regulator end fitting into cylinder
valve, rotate coupling nut clockwise and tighten firmly.
3. Open valve on propane cylinder slowly. If the valve is not
opened slowly, the excess flow check valve in the regulator
will stop the flow of gas. If this should happen, close the
valve, wait one minute (or until you hear the valve click), and
re-open, slowly.
4. Be sure to inspect all connections for leaks, by using a
50/50 mixture of dish soap and water on all connections.
Any bubbles forming indicate a leak.
12

ASSEMBLY

Regulator
LP Cylinder
Valve
Coupling
Nut
Propane Heater Manual

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido