Metra 95-5806 Instrucciones De Instalación página 3

1. Attach the double DIN brackets
to the radio using the screws that
came with the radio. (Figure A)
2. Trim the sub-dash in the upper left
corner. (Figure B)
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
4. Insert radio and kit into dash and
snap assembly into the dash.
Note: Some aftermarket radios
will not fit into the opening of the
original bezel. If this is the case,
with your installation, the bezel will
have to be carefully trimmed to
allow the radio to snap-in.
5. Reassemble dash in reverse
order of disassembly.
Kit Assembly 95-5806
Double DIN radio provision
(Figure A) (Figure B)
3