ITT Goulds Pumps AquaBoost II Instalación, Operación Y Mantenimiento página 11

8. Switch Settings With Power Applied (Cont'd.)
Figure 4 Switches and Status Indicator
Run/Program (jumper
must be on left 2 pins for
controller to run)
Minimum Speed Switch
Dry Run Restart Switch
Pressure Adjust
Pushbuttons
Figure 5
Typical Motor Nameplate Showing Service Factor Amps (SF AMPS)
Service Factor Amps (SF AMPS)
that are used to set the Motor
Overload Setting Switches.
In this example, if controller is supplied with 208 V, use the 4.2 Amp setting indicated on the Motor
Overload Setting Switch.
11
Motor Overload Setting
Switch (3AB2 current limits
shown. 5AB2 has 16.6A
Max. setting)
Status Indicator
Ramp Setting Switch