Denon Professional DN-V200 Instrucciones De Operación página 7

(2) Connecting to a TV or Monitor Equipped with Color Component Input
Connectors
Color component output connectors (P /C
R R
The red (P /C ), blue (P /C ) and brightness (Y) signals are output independently,
R R B B
achieving more faithful reproduction of the colors.
• The color component input connectors may be marked differently on some TVs or
monitors (P , P and Y/R-Y, B-Y and Y/C , C
R B R
TV's operating instructions.
• If your TV is compatible with progressive scan, press the "SHIFT" and "P.SCAN"
button on the front panel so that "P.SCAN" lights on the display. This results in a
high quality picture with little flickering.
(No signals are output from the Video out, S-Video output (S terminal) or SCART
terminal (AV1) output when "P.SCAN" is lit.)
• Select "COMPONENT OUTPUT" for the video output setting at the setup screen.
(When "COMPONENT" is selected, no video signals are output from the S-Video
output (S terminal) and RGB of SCART terminal (AVI).
DN-V200/DN-V300
P /C P /C Y
R R B B
COMPONENT VIDEO IN
NOTES:
• Use the three commercially available video cords to connect the DN-V200/DN-V300's color component
output connectors to the TV or monitor.
• Set the "TV TYPE" in "VIDEO SETUP" in "SETUP" to comply with your TV's video format. When the TV
is PAL formatted, set to PAL. (See page 14.)
• Set the "VIDEO OUT" in "VIDEO SETUP" in "SETUP" to comply with Progressive TV.
• To use with 2-channel audio output, set "STEREO" in "DOWNMIX" in "AUDIO SETUP" in "SETUP" at
the initial settings. (See page 15)
• Set the "TV ASPECT" in "VIDEO SETUP" in "SETUP" to comply with your TV's aspect. (See page 13)
• No audio signals are output from the DN-V200/DN-V300's "AUDIO OUT" connector when discs recorded
in DTS are played.
, P /C and Y)
B B
and Y, etc.). For details, refer to the
B
TV
AUDIO IN
L R
(3) Connecting to a TV with 21-pin SCART Terminal (For only European model)
• Use the commercially 21-pin SCART cable to connect the TV's 21-pin SCART terminal to the DN-V200/DN-
V300's 21-pin SCART terminal (AV1).
• Check that "P.SCAN" on the front panel display is off.If "P.SCAN" is lit, press the "SHIFT" and "P.SCAN"
button on the front panel so that "P.SCAN" turns off. Pictures are not output properly if "P.SCAN" is lit.
• Select "RGB" for the video output setting at the setup screen video setup.
• CVBS and RGB signal are output from the SCART terminal (AV1).
When "RGB" is selected, no video signals are output from the S-Video output (S terminal) or component
output.
When "RGB" is selected, CVBS and RGB are output.
21-pin SCART terminal
TV
DN-V200/DN-V300
• Some discs contain copy prohibit signals. If such
discs are played via a VCR, the copy prohibit
system may cause disturbance in the picture.
To power outlet
NOTES:
• Set the "TV TYPE" in "VIDEO SETUP" in
"SETUP" to comply with your TV's video format.
When the TV is PAL formatted, set to PAL. (See
page 14.)
ENGLISH
7