Publicidad
ENGLISH
20
TROUBLESHOOTING
Check again before assuming the player is malfunctioning.
2
Are all the connections correct?
Are you following the instructions in the manual?
2
Are the amplifier and speakers operating properly?
2
If the DN-V200/DN-V300 does not seem to be functioning properly, check the table below. If this does not solve
the problem, the DN-V200/DN-V300 may be damaged. Turn off the power, unplug the power cord from the
power outlet, and contact your store of purchase or nearest sales office.
Symptom
Power does not turn on.
• Plug the power cord securely into the power outlet.
Playback does not start
• Is there condensation on the disc or player? (Let stand for 1 or 2 hours.)
when PLAY button is
• Discs other than DVDs, video CDs and music CDs and Digital picture (JPEG)
pressed.
cannot be played.
Playback stops
• Disc is dirty. Wipe off the dirt.
immediately.
• Check the connections.
• Turn "P.SCAN" off when a TV is connected to the VIDEO OUT, AV1 and S-VIDEO
Picture does not appear.
connector.
• Set the TV's input to "video".
• Check the connections.
Sound is not produced or
• Properly set the input of the TV, stereo, etc.
sound quality is poor.
• Check the "DIGITAL OUT" and "COMPRESSION" settings.
Menu playback is not
• Check the "AUTO PLAY" setting.
possible.
• Menu playback is not possible with anything but video CDs with playback control.
Picture is disturbed during
• Some disturbance is normal.
the search operation.
• Some operations are disabled for some discs.
Buttons do not operate.
• Check the "KEY LOCK" mode.
• Subtitles are not displayed for DVDs not containing subtitles.
No subtitles are displayed.
• Subtitles are turned off. Turn the subtitles setting on.
• The audio (or subtitle) language does not switch for discs which do not include
Audio (or subtitle)
multiple audio (or subtitle) languages.
language does not switch.
• For some discs the audio (or subtitle) language cannot be switched when the
operation to switch it is performed, but can be switched on the menu screens.
• The angle cannot be switched for DVDs which do not contain multiple angles. In
Angle does not switch.
some cases multiple angles are only recorded for specific scenes.
Playback does not start
• Check the "RATING" setting.
when the title is selected.
• Use the procedure described below to set the initial settings back to the values set
The password for rating
when the unit was shipped from the factory. Input "1470" at 5 under step 3 on
level has been forgotten.
page 17.
The disc is not played
• The disc does not play with the selected audio or subtitle language if that audio or
with the audio or subtitle
subtitle language is not included on that DVD.
language set as the
default setting.
Picture is not displayed in
• Set the "TV ASPECT" default setting to the proper setting for the connected TV.
4:3 (or 16:9).
Menu screen messages
• Check the default setting for the disc language's menu language.
for the desired language
do not display.
32
Check
Page
6~9
—
5
6
6~9
6, 7
—
6~9
—
14
17
18
—
18
28
—
16
—
24
23
17
—
15, 16
13
16
21
MAIN SPECIFICATIONS
Signal system:
NTSC/PAL
Applicable discs:
(1) DVD discs
1-layer 12 cm single-sided discs, 2-layer 12 cm single-sided discs, 2-layer 12 cm
double-sided discs (1 layer per side)
1-layer 8 cm single-sided discs, 2-layer 8 cm single-sided discs, 2-layer 8 cm
double-sided discs (1 layer per side)
(2) Compact discs (CD-DA, Video CD)
12 cm discs, 8 cm discs
Y output level: 1 Vp-p (75 Ω/ohms)
S-Video output:
Output connector: S connector, 1 set
Output level: 1 Vp-p (75 Ω/ohms)
Video output:
Output connectors: Pin-plug jack, 1 set / AV 1, 1 set
Y output level: 1 Vp-p (75 Ω/ohms)
Component output:
output level: 0.7 Vp-p (75 Ω/ohms)
P
/C
B
B
Output connector: Pin jack, 1 set
Output level: 0.7 Vp-p (75 Ω/ohms)
RGB output:
Output connector: AV 1, 1 set
Audio output:
Output level: 2 Vrms
2 channel (FL, FR) output connector: Pin jacks, 1 set / AV 1, 1 set
Audio output
properties:
(1) Frequency response
q DVDs (linear PCM) : 4 Hz to 22 kHz (48 kHz sampling)
w CDs
(2) S/N ratio
q DVDs
w CDs
(3) Total harmonic distortion
q DVDs
w CDs
(4) Dynamic range
q DVDs
w CDs
Digital audio output:
Optical digital output
Coaxial digital output
Power supply:
AC 230 V, 50 Hz
Power consumption:
19 W
Maximum external
dimensions:
434 (width) x 80 (height) x 360 (depth) mm (including protruding parts)
Mass:
3,9 kg
Remote control unit:
RC-963
2
Type:
Infrared pulse
Power supply:
DC 3 V, 2 R03/AAA batteries
This product incorporates copyright protection technology that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by Macrovision Corporation and other rights owners.
Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended
for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation.
Reverse engineering or disassembly is prohibited.
Design and specifications are subject to change without notice in the course of product improvement.
C output level: 0.3 Vp-p
output level: 0.7 Vp-p (75 Ω/ohms)
P
/C
R
R
: 4 Hz to 44 kHz (96 kHz sampling)
: 4 Hz to 20 kHz
: 110 dB
: 110 dB
: 0.006%
: 0.004%
: 100 dB
: 95 dB
: Optical connector, 1 set
: Pin Jack, 1 set
Publicidad
Capítulos
Solución de problemas
