Quick Start Instructions:
Quick Start Instructions:
1) Batteries - This weather radio operates on AC power or four (4) AA
alkaline batteries (not supplied). To install batteries, remove battery hatch
and insert batteries into the compartment on the underside of the unit.
2) AC Power Adapter - Plug the radio into a standard 120 volt outlet. Plug
the AC adapter into the back of the radio at input marked DC 6V 300mA.
3) Program the Time - Press and release the MENU button. "TIME" will be
displayed. Press and release the SELECT button. Use the UP/DOWN
directional arrow buttons to set the hour. (Note AM/PM indicator.)
Change to minutes by pressing the RIGHT directional arrow button, and
use the UP/DOWN directional arrow buttons to set the minutes.
4) Weather Radio Switch - Ensure the unit is in weather radio mode by
turning the switch on the left side of the unit to ON.
5) Program the Weather/Hazard Channel for Your Area
Turn switch on the top left side of radio to the ON position.
Press MENU.
Press UP directional arrow until "CHANNEL" is displayed.
Press SELECT.
Press UP directional arrow until you hear the broadcast of your
station.
Press SELECT to save station selection.
Press MENU to close menu mode.
Press WEATHER/SNOOZE to turn Weather/Hazard broadcast on
again.
You are now able to receive weather alerts for your area and
surrounding areas.
For the best possible reception, pull out the antenna and extend it to
its full length above the weather radio.
2