collaxx FL100 Manual De Instrucciones De Montaje Y De Manejo página 10

Status memory
The lamp has a status memory. When the light unit is
switched on, the same status that was active at the time
when it was switched off will be activated. The status
memory also works if you switch off the lamp by interrupting
the power supply to the lamp. If automatic mode was active,
it always starts with red.
Troubleshooting
If your lamp does not respond to the remote control
commands, check at first whether the power supply is ok.
Then perform a synchronization.
The battery is designed for 28 years standby respectively
10 million button activations. Therefore, the possibility that
the fault has been caused by an empty battery can be
ruled out safely.
Never try to repair a faulty lamp! Always send it back with
all accessories (power supply unit, remote control). Please
enclose a description of the error and a copy of your receipt.
Warranty
The statutory warranty applies from the date of the invoice.
Therefore, please always ensure that you keep your receipt
safe.
Your warranty claims are null and void if you open the
housing of the diode or the remote control or if you subject
the components to an excessive ambient temperature.
Use only the supplied power supply unit to supply power
to the lamp.
10