collaxx FL100 Manual De Instrucciones De Montaje Y De Manejo página 9

Operating instructions
For an allocation of the below-mentioned symbols to your
lamp type please refer to fig. Ⓑ on page 2.
Switch through the following colours sequentially by
pressing the button =:
1. Red
2. Yellow
3. Green
4. Blue
5. Daylight White
6. Automatic Mode
The red – yellow – green – blue colours show
sequentially at the programmed speed
7. Off
By pressing the button = anew, the program starts
again with 1. (red)
The lamp can be switched off at any time by keeping the
button = pressed.
If your lamp is equipped with a 3-key remote control F3
(with dimming function):
> keep pressed for brightening
< keep pressed for darkening
Synchronization
This section is only relevant if your colour light appliance is
equipped with a remote control.
Every remote control has been assigned a serial number.
The lamp must be synchronized with the remote control
before it responds to the remote control commands. This
is done by the manufacturer. To perform the synchronization
yourself, please proceed as follows:
1. Unplug the lamp
2. Wait for at least 10 seconds
3. Plug in the lamp again
4. Press the = button on the remote control within 10
after you have plugged in the lamp
By performing the above synchronization procedure, you
can operate several lamps at the same time using only one
remote control.
Automatic mode programming
The factory setting of the colour change interval in automatic
mode is 5 minutes. You can change this interval as many
times as you wish by proceeding as follows:
1. Switch off the lamp
2. Keep the button = pressed and release it only after
the lamp has switched from red to yellow
3. The programming mode is now active. Leave the yellow
light on for the desired interval (10 seconds up to 4
hours).
4. Then shortly press the button = to change the colour.
The time that has elapsed since the activation of the
programming mode is saved. It is the new automatic
interval for all colours.
EN
9