Charging The Battery - Hoover ONE PWR SYSTEM FLOORMATE JET Manual De Instrucciones

CHARGING THE BATTERY

Ensure that the battery is fully charged prior to use. This may take 3-4 hours to fully charge. The battery will not ship fully charged due to federal regulations.
1
Plug the charger
into a power outlet.
TIPS
During charging, the pack and ambient temperature should be between 41°F to 86°F (5°C and 30°C). The charger will sense if the pack, or ambient temperature, is too cold or too hot, and will
return an error code (red LED will be on) and not charge the pack. Use battery only with charger listed. For use with Hoover ONEPWR Lithium Ion Batteries.
6
2 3
Align the ribs on the ONEPWR When charging, the lights on the
Battery to the grooves in the battery will illuminate to show
charger. Slide the battery the state of charge. If the light on
pack into the charger. the charger flashes red, there is
an error with the battery or the
charger. Remove battery from
charger and try again.
4 5
When charged the lights on the To remove the battery pack from
battery will turn off and the light the charger, press the latches
on the charger will be solid. and pull up on the
battery pack.