Cleaning Floors - Hoover ONE PWR SYSTEM FLOORMATE JET Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING FLOORS

1
Recline by placing a foot gently on the
base of the cleaner and pull the handle
backwards.
TIPS
Dried Messes: To clean dried messes on hard floors, use trigger to spray solution onto dried mess and allow to sit for 1-2 minutes. Pass the brush roll over mess until clean.
Wet Messes: To clean wet messes on hard floors, pass over the mess until removed, then use trigger to spray solution onto floor. Pass the brush roll over remaining mess until floor is clean.
2
Use the Power Button (1) to turn ON/
OFF. The Mode Selector (2) will change
between HIGH for large messes and ECO
for extended run time. The Display Panel
(3) will indicate the current mode and
battery change level.
3
2
1
3
Engage the trigger on the handle to
dispense solution as desired.
4
On forward stroke, tap trigger as
needed to dampen brush roll and extract
on backwards strokes.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido