Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Complete the Installation
If applicable, carefully remove the protective tape from the bath rim.
Using silicone sealant, seal the joints between the bath rim edges and the water-resistant deck
material.
Enclose the bath by adding the remaining side walls to the framing.
If you have not already done so, attach the access panels.
Install the faucet trim according to the manufacturer's instructions.
5. Complete the Wiring
Refer to the Installation Guide packed with the digital interface and media module for proper
installation.
Troubleshooting
CAUTION: Risk of personal injury. The digital mixing valve (if installed) may contain hot water;
be careful when draining any residual water.
IMPORTANT! Turn off the power and water supply to all components before performing any
maintenance.
It is recommended that any digital mixing valve maintenance should be performed by a Kohler Co.
Authorized Service Representative.
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4-KOHLER.
Digital Interface Troubleshooting Table
Symptoms
1.
Digital interface is not lit.
Kohler Co.
Water-Resistant Wall Material
Probable Cause
A. Media module is not plugged
into the outlet.
B. Power supply connection to the
media module may be loose or
disconnected.
C. Interface cable connections may
be loose or disconnected.
D. Circuit breaker has been
tripped.
9
Apply silicone sealant.
Finished Deck Material
Recommended Action
A. Plug the media module into the
outlet.
B. Check power supply connections to
the media module and reconnect if
needed.
C. Check all interface cable
connections, connect if needed.
D. Reset the circuit breaker.
1078024-2-A
Publicidad
Tabla de contenido
