Important - Euroflex Monster SC60 Superclean Manual De Instrucciones

Using Monster 60 SuperClean with Floor Brush
Step 1: Connect one of the extension tubes to the
steam gun on the flexible steam hose. To attach
the extension tubes one onto the other or onto
the steam gun, press the locking button ensuring
that it fits into the hole. To disconnect, repeat the
operation by pressing the locking button and
pulling the two sections apart.
NOTE: Fit floor brush with the brush adaptor on to
the extension tube.
Step 2: If the brush adaptor is not attached to
the floor brush, hold the brush with its bristles up
in your left hand. With the brush adaptor pointing
downward, insert it into the hole in the back of the
brush, then turn the brush adaptor 180°.
Step 3: Insert the electrical power plug into the wall
socket. Heating time is approximately 5 minutes
with cold water. Filling the boiler with hot water
will shorten heat up time.
Attaching a Cotton Cloth to the Floor Brush
The cotton cloth provided can be fitted on this
brush so as to absorb the dirt and protect de-
licate surfaces. It can also be used on vertical
washable surfaces following the same procedure
as for the floor.
IMPORTANT: When using floor brush to clean
timber, parquetry, painted walls and ceilings,
to avoid scratching the surface make sure that
cotton cloth is securely attached and that none
of the bristles break through. If necessary use 2
cloths.
Operating Instruction (cont.)
23
Fitting the cotton cloth
1. Place the brush on the cloth.
2. Fold the cloth as shown below.
3. Fold other side as shown below
4. Place the corner under the cloth holder as
shown
5. Repeat for the other end of the brush head,
pulling the cloth to stretch it into place.