Care & Maintenance; Fitting A Different Plug - Euroflex Monster SC60 Superclean Manual De Instrucciones

If you always use demineralised or distilled wa-
ter, cleaning the boiler is unnecessary.
Rinsing out the steam cleaner:
Normally, a periodic rinse of your Monster 60
SuperClean will free it from deposits. This is re-
commended every 10-15 tankfulls, to free up
any scale deposits from the tank.
Fill the boiler with water and shake the cleaner
vigorously. Tilt the cleaner upside down to empty
the boiler of water and any scale deposits.
Descaling your steam cleaner:
If the tap water in you area contains a high
level of calcium deposits and you have been
using tap water to do your steam cleaning, your
should descale your unit after 10-15 tankfulls.
Step 1: Unplug the steam cleaner from the
power source before you descale the boiler.
Step 2: Fill the boiler with 1 part (150 ml, pt) vine-
gar and 4 parts (600 ml, 1 pt) water and leave
overnight or for a period of approximately 8
hours. Do not screw the safety/fi ller cap onto
the steam cleaner while you are descaling the
boiler.
Step 3: After the period of soaking, turn the
steam cleaner upside down to empty solution
from the boiler. Due to the fact that a small
amount of solution will be left in the boiler, it
is necessary to rinse the boiler out with clean
water 2 or 3 times.
Your steam cleaner is now ready for use.
Do not use the steam cleaner while descaling
solution is inside the boiler.
Attaching the Shoulder Strap
Using the detachable shoulder strap allows for
greater freedom of movement when both han-
ds are needed for various cleaning tasks.
To attach the shoulder strap to the steam clea-
ner, simply snap the shoulder strap hooks onto
the connecting rings on the unit body.
See illustration below.
Care & Maintenance
When using the Monster 60 SuperClean with the
shoulder strap, avoid rocking or tilting the unit
excessively as this may cause water to enter the
hose and be discharged along with the steam.
Fitting A Different Plug (UK Only)
This appliance is already fi tted with a BS 1363
13 Amp. plug. The wires in the mains lead are
coloured as follows:
Green and yellow: Earth
Blue:
Brown:
Should you need to replace the plug, please
read the instructions and connect the wires as
detailed below.
If in any doubt, consult a qualifi ed electrician.
The coloured markings identifying the terminals in
your replacement plug may not correspond with
the colours of the wires in the mains lead of this
appliance, so proceed as follows:
The wire that is coloured green and yellow must be
connected to the terminal marked with the letter
E, or the earth Symbol
green and yellow.
Always fi t the same value of fuse as that originally
supplied with your appliance.
Only use BS 1362 approved fuses.
As a guide only:
Appliances under 700 W can have a 3 Amp. fuse
(red) and all others should have a 13 Amp. fuse
(brown).
When disposing of an old plug (particularly the
moulded type that has been cut from the mains
cord) always remove the fuse as the plug could be
dangerous if ever inserted in a live socket.
28
Neutral
Live
, or coloured green or