Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
WARNING! User must read the product
manual to fully understand this product prior
to use, and follow all safety instructions as outlined
in the WORXAIR
Operator's Manual.
TM
CAUTION!The user must wear the
appropriate clothing and safety goggles when
operating this product. Be aware of all bystanders,
pets and objects in a close proximity.
DO NOT operate blower and attachments when
•
fatigued.
DO NOT overreach or stand on unstable
•
support. Keep good footing and balance at all
times.
•
Never direct airflow towards bystanders. Always
be aware of the direction that the debris will be
thrown.
•
Use a face filter mask to avoid breathing dust
and debris.
WARNING: This product maybe contains lead,
phthalate or other chemicals known to the State of
California to cause cancer, birth defects and other
reproductive harm. Please wash your hands after
use.
ASSEMBLY AND
OPERATION
1. ATTACH THE GUTTER KIT AS SHOWN IN
Fig. A1:
Connect the (1, 2, 3) components by screwing
together. Snap the (3, 4) components together.
2. ASSEMBLING THE UNIVERSAL ADAPTOR
(1) Place the fabric side of the Universal Adapter
over the Blower Outlet and slide it on as far as
possible (B1).
WORX TURBINE
models-Place the fabric
TM
side of the Universal Adapter over the outlet
of the Fan Housing and slide it on as far as
possible(B1.1).
WORX TRIVAC
models - Place the fabric side
TM
of the Universal Adapter over the Vacuum Outlet
and slide it on as far as possible (B1.2). Before
operation, flip the blow/vac switch into the
vacuum mode.
PLEASE NOTE: Items can be vacuumed
through the vac inlet and pass through or
become clogged within the gutter kit. Please
keep the vac inlet away from objects while using
the gutter kit.
(2) Check to make sure the strap is threaded
through the locking mechanism. Then pull to
tighten the strap (B2). Increase the tension by
pulling the latch up and down to tighten (B3).
To loosen, simply press the two outside latches
down and then pull the strap out from other side
(B4).
GUTTERPRO Universal
Gutter Cleaning Kit
(3) Test that the Universal Adapter will not slide off
of the blower outlet.
(4) If further tightening is needed, then pull the
middle latch up and down until the adapter
is tight. Please recheck if it will slide off of the
blower outlet. Realign and repeat these steps
if needed (B3). To loosen, simply press the two
outside latches down and then pull the strap out
from other side (B4).
PLEASE NOTE: The Universal Adapter may have
space between the Blower Outlet and Adapter
Outlet after installation.
To remove the adapter, simply press the two outside
latches down and loosen the strap to remove it from
the Blower Outlet (B4).
NOTE:
Use only enough Gutter Tube Extensions to
comfortably reach the inside of the gutter.
3. OPERATE ACCORDING TO Fig. C:
The Gutter Tube Nozzle can be adjusted to any
desired direction by rotating the Gutter Tube
Connecter as shown in Fig. D. Gutter cleaning
applications will vary. It is recommended to try
various positions to find the most effective working
position for the type of house and gutter design.
5
EN
Publicidad
