Toro TBC WP Guía Del Usuario E Instrucciones De Instalacion página 6

Connecting the Rain Sensor
The TBC WP sensor is designed for a normally closed sensor.
TM
The following example will illustrate how to connect a wired Toro RainSensor
controller. Other normally closed sensors can be installed to the controller as well, such as
moisture, rain, etc.
Step 1 –
Route wires from the rain sensor to
the TBC
Step 2 –
Cut the wire loop (yellow) from
TBC WP controller's Sensor A and B.
TM
Strip approximately 1/2" (1.25 cm)
of insulation from the wires and
connect them to the rain sensor wires.
Wire polarity is not observed in this
application.
NOTE:
wire connectors (not supplied) for this
application.
IMPORTANT:
installed, the TBC
Sensor A and B wires must be
connected together. Otherwise, the
controller will assume that rain is
being detected and it will prevent
programs from activating.
6
WP controller.
TM
Use water sealed/proof
If a rain sensor is not
WP controller's
TM
to the
TM