Hanging The Fan - HAMPTON BAY 91100 Guía De Uso Y Cuidado

Assembly - Hanging the Fan
1
Attaching the mounting bracket to
the outlet box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
"Acceptable for fan support of 35 lbs. (15.9 Kg) or less,"
and use the screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (1)
installed.
□
Loosen the two mounting screws (1) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (1)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side
of the slide-on mounting bracket (A) should face toward the
outlet box, as shown.
□
Securely tighten the two mounting screws (1).
1
2
□
□
□
JJ
1
A
8

Hanging the fan

WARNING: The hook (JJ) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (JJ) breaking, causing the fan to fall.
The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (JJ) it is critical
that you use one of the non-slotted (round) holes in the
canopy (C).
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
Insert the ball portion of the ball/downrod assembly into the
socket of the slide-on mounting bracket.
Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket aligned with the
slot in the ball.
Standard Mount
A
B
M
C
D
E