Truth Or Myth - GE PVD Manual Del Propietario E Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Truth or Myth

SERVICE
Truth or Myth
Truth or Myth?
The refrigerator water filter may require
replacement, even though the filter indicator
The automatic ice maker in my refrigerator will
produce ice when the refrigerator is plugged
in to a power receptacle.
After the refrigerator has been plugged in and
connected to water, I will immediately have
unlimited chilled water available from the water
dispenser.
After water dispenses, a few drops of water
are normal.
compartment.
When the refrigerator is installed, or after
replacing the water filter, I must dispense
water for five minutes.
To fill the ice bucket to the maximum capacity,
I should dispense 12 and 18 hours after
installation.
I can use the water filter bypass plug to
determine if the filter requires replacement.
The top of the refrigerator doors will always be
aligned.
Refrigerator door handles can be easily
tightened.
There may be odor and taste problems with
your ice.
I can make fine adjustments to the
40
Before you call for service, review the detailed troubleshooting tips in the Owner's manual.
If needed, service can be scheduled by visiting us online GEAppliances.com or calling
800.GE.CARES 800.432.2737. In Canada visit GEAppliances.ca or call 800.561.3344.
Answer
MYTH
MYTH
MYTH
MYTH
Explanation
The water filter indicator will indicate the need to replace the water
filter every six months. Water quality varies from city to city; if water
flow from the dispenser slows, or ice production decreases, the
water filter should be replaced, even though the filter indicator may
not indicate the need for replacement.
The refrigerator must be connected to water, and the ice maker
must be turned on. Make sure the ice maker is turned on, only after
the water line is connected and water is turned on. The ice maker
can be turned on off from the controls and ensure the ice maker is
on, as indicated on the refrigerator control panel. See Automatic Ice
Maker section in the full owner's manual available online.
The water dispenser tank located inside the refrigerator stores water
for dispensing. The water in this tank requires 24 hours to chill after
installation. High usage conditions will not allow time for the water
to chill.
A few drops of water may fall from the dispenser, after the dispenser
slowly from the dispenser.
properly sealed, or has been left open. If frost is found, clear the
frost using a plastic spatula and towel, then check to ensure that no
closing. Check the refrigerator control panel to ensure the door
alarm is on.
A newly installed refrigerator or water filter contains air in the water
lines. Press the dispenser paddle and dispense cold water for at
least 5 minutes to remove air from the water line, and flush the filter.
allows ice to disperse within the ice bucket, which in turns calls on
the ice maker to produce additional ice. Normal ice production = 100
cubes in 24 hours.
production, may indicate the need to replace the water filter. Install
the water filter bypass plug (provided with the refrigerator on some
models*), and check flow from the dispenser. If water flow returns to
normal with the bypass plug in place, replace the water filter.
Several things can affect the refrigerator door alignment, including
the floor the refrigerator is installed on and loading of doors. If the
on the bottom right or left hand side of the door. Refrigerator doors
access the screw. See Step 8.
If door handles are loose or have a gap, the handle can be adjusted
handles.
After starting the ice maker throw away 24 hours of ice production to
avoid odor and taste problems.
adjust the right hand door. The adjustment screw is located on the
49-1000332 Rev. 1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gve

Tabla de contenido