ION PROJECT ROCKER Guia De Inicio Rapido página 7

Operation
Pairing a Bluetooth Device
1. Turn on your Bluetooth device.
2. Power on Project Rocker. If you have previously connected to another Bluetooth device,
Project Rocker will reconnect. To disconnect pairing if the Bluetooth icon is lit solid, press
and release the Bluetooth button.
3. Navigate to your Bluetooth device's setup screen, find "Project Rocker" and connect.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
To disconnect pairing while the Bluetooth icon is lit solid, press and release the Bluetooth
button.
To connect to another Bluetooth device, repeat step 3.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0 or higher.
Pairing a Bluetooth Device Using NFC
NFC (near-field communication) allows data exchange from devices, such as pairing, by gently
bumping them together. Check in your device's manual to see if this feature is supported.
To use NFC to pair with Project Rocker:
1. In order to use NFC, your device must be turned on and unlocked.
2. Enter your device's Settings menu and check that NFC is turned On (one-time step).
3. Power on Project Rocker.
4. Touch and briefly hold your device to the NFC logo located on Project Rocker's top panel.
5. Follow the pairing instructions that appear on your phone. If a passcode is required, enter
"0000".
6. To unpair, gently bump your device against the NFC logo.
Using the Radio
Selecting a radio station:
1. Press the Radio button.
2. Use the Tune/Track (</>) buttons to search for a radio station. To "seek" (jump to the next
available station), hold a Tune/Track button down for a few seconds until it starts to seek
a station. The unit will remember the last station you were on and start at that station when
you power off and power on again.
7