ION PROJECT ROCKER Guia De Inicio Rapido página 8

Saving a preset:
1. Press the Radio Selector button to choose FM/AM and select a radio station that you
want to save to a preset location using the Tune/Track (</>) buttons.
2. Press and hold Play/Pause for 3 seconds. A preset number will appear on the screen.
3. Use the </> buttons to select which preset you want to save it to.
4. Press Play/Pause to confirm. SAVE will appear on the screen.
Selecting a preset:
1. Press and hold Play/Pause for 3 seconds. A preset number will appear on the screen.
2. Use the </> buttons to cycle through the saved presets. The preset will load after a few
seconds.
Troubleshooting
If the unit is not charging: Make sure the power cable is properly connected to the power
input and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source. Also, try to
reduce the overall volume of Project Rocker using the Master Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is poor AM reception: To adjust AM reception, move entire unit.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
If you cannot connect your audio device to Project Rocker via Bluetooth:
•
Have your audio device (e.g., smartphone or tablet) and Project Rocker as close together
as possible while trying to connect. Make sure both the audio device and Project Rocker
are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Project Rocker to disconnect Project Rocker from any
other audio device and restart the search process. If this does not work right away,
power off Project Rocker and then power it back on. See
more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back
on. You can find this under the Bluetooth menu in the Settings for your phone or other
audio device.
If this does not work, and you have connected to Project Rocker before, find Project
Rocker in the list of available or previously connected devices in your audio device's
Bluetooth menu, tap the "gear" or "i" icon located next to it and then select Unpair or
Forget. Turn Project Rocker off and back on and try pairing again once it reappears in
your available devices list.
Note: If Project Rocker has been paired to another audio device recently that is still
within range, you may need to repeat this process with that audio device to fully
disconnect.
8
Pairing a Bluetooth Device for