Kenmore 116.21714 Manual De Uso Y Cuidado página 24

Always follow all safety precautions when performing maintenance to the PowerMate.
WARNING
Electrlcal Shock Or Personal injury Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Fallure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
Quick _"_ II /
Release _._ 4
3. Turn
PowerMate
upside down and
unscrew four (4)
PowerMate cover
screws.
1. Turn off and
unplug vacuum
cleaner.
2. Remove the
wand by pressing
the quick release
pedal and lifting
up on the wand.
Screws
Release
4. Turn PowerMate
right side up.
5. While holding
the swivel, press
handle release
pedal and lower
the swivel.
6. Lift rear
latches up.
Sid_
tch
Rear
Latches
7. Grasp the side
latches and pull
out.
8. Lift cover
upward from
back to remove.
position of all
wiring and dirt
sensor board. Lift
agitator assembly
out and remove se
worn belt.
End Cap
10. Check and clean end cap areas. See
AGITATOR ASSEMBLY (page 25) for picture
of complete agitator assembly.
- 24 -