Connecting The Baby Unit; Connecting Baby Unit And Parent Unit; Power Supply - NUK Babyphone Eco Control Audio 530D Manual Del Usuario

data (see "9. Technical
page 41).
6. Initially, charge
continuously for 10 hours to activate the
full battery capacity (see "4.4 Power
supply" on page 31).

4.2 Connecting the baby unit

Note: Don't install the baby unit 1 until the
battery of the parent unit 11 is fully charged.
1. Put the baby unit 1 somewhere in the
nursery where your baby will not be able
to reach it.
An optimal distance between baby and
the baby unit is from 1 to 2 m.
2. Insert the mains adapter plug into the
socket 3 of the baby unit 1.
3. Insert the plug into a power socket that
matches the rating given in the technical
data (see "9. Technical
page 41).
4.3 Connecting baby unit and
parent unit
1. Use the On/Off button 7 to switch the
baby unit 1 on. Keep the button pressed
for a moment until the Power LED 9 lights
up.
2. Use the On/Off button 17 to switch the
parent unit 11 on. Keep the button
pressed for a moment until the LED 18
lights up green.
The connection
automatically. While this is being done
the connection indicator 16 will light up
red.
As soon as the connection has been
established, the connection indicator on
the parent unit 16 and the VOX LED on
the baby unit 10 will light up green.
If the connection indicator 16 begins to
flash green, this means that there is a
connection between the parent unit and
the baby unit, but your baby is currently
asleep and therefore the device has
data" on
the parent unit
data" on
will be set up
automatically activated Eco-Mode to
reduce the high-frequency radiation in
the children's room and save energy.
In the event that the connection between
the parent unit and the baby unit breaks
down, the devices will automatically attempt
to establish a new one.
If a new connection is not established within
30 seconds, the parent unit 11 will emit a
regular beep
indicator 16 will light up red. You may need
to move the parent unit to a different
location before a new connection can be
established.
3. First go and check on baby to make sure
everything is OK.
4. Then try to set up a new connection by
moving about.
The connection will be automatically re-
established as soon as you are within
range.
As soon as the connection has been set
up the connection indicator 16 will again
light up green.

4.4 Power supply

• The power supply for the baby unit 1
works only via the mains adapter.
• The parent unit 11 can be operated using
the battery with no mains connection for
up to 18 hours.
Displays
The level of charge in the battery is indicated
by the LED POWER 18. While the parent unit
is switched on, its level of battery charge is
indicated by the additional battery symbol in
the display:
LED 18 is green
and continuously
on
31
and the connection
Battery is fully charged