Adjusting The Volume Control; Mute Setting - NUK Babyphone Eco Control Audio 530D Manual Del Usuario

• The TALK symbol is visible
only while the talk-back
function is active (see "6.7 Talking to your
baby" on page 37).
• The musical note symbol will be
visible only if lullabies have been
activated from the parent unit
(see "6.8 Lullabies" on page 38)
or baby unit (see "5.3 Lullabies" on
page 34).
• The lightbulb symbol will be
visible only if the nightlight has
been activated from the parent
unit (see "6.9 Nightlight"
page 38) or
"5.4 Nightlight" on page 34).
• The battery symbol is also
always displayed and shows the
battery's current charge level
(see "4.4 Power supply" on page 31).
• The loudspeaker
symbol always
shows you
device's current volume setting (see
"6.4 Adjusting the volume control" on page
36 and "6.5 Mute setting" on page 36).
If no bars are shown, then the device is
currently muted (see "6.5 Mute setting"
on page 36).
6.4 Adjusting the volume
control
• You can use the VOL + 13 and VOL - 14
buttons to set the volume at which you
hear the sounds emitted by the parent
unit.
Each time you press one of the buttons
you will hear a beep at the volume that is
currently set and the corresponding
LEDs 19 will be illuminated The louder
your chosen setting, the louder will be
any beeps and the more LEDs will light
up.
on
baby unit
the
The display
shows a number of
bars indicating
current volume setting. The louder your
chosen setting, the louder the unit will
beep and the more bars will appear.
Note: When the VOX function is set to
low sensitivity (see "6.6 Using the VOX
function to
sensitivity" on page 37), then quiet
sounds will not be transmitted regardless
of the volume setting. This means that
turning up the volume will not enable you
to hear anything more. If you want to hear
(see more of the sounds from the nursery you
will need to increase the transmission
sensitivity by selecting a higher VOX
level.

6.5 Mute setting

The parent unit can be "MUTED". Sounds
from the nursery will then no longer be
transmitted.
1. Press the VOL - 14 button repeatedly
until no more beeps are heard.
No further sounds will be transmitted.
The display 15 shows
the loudspeaker symbol
with no bars.
The LEDs 19 will continue to indicate the
noise level in the nursery. The more LEDs
are lit the louder are the noises in the
nursery.
2. You can cancel the mute setting by
pressing the VOL + 13 key.
3. If the parent unit is muted and you
activate the talk-back function, the
volume will automatically return to the
first level.
Caution!
If you mute the parent unit and also activate
the lullabies then you will no longer have any
active monitoring function. The five LEDs
that display the volume 19 are switched off
while a lullaby is playing. If you also mute
the device then you will neither be able to
36
also
the
adjust the transmission