Display Cycle Count; Operation - Drucker Diagnostics HORIZON 12 FLEX Manual Del Operador

D C C
ISPLAY YCLE OUNT
These actions will display the cycle count.

Display Cycle Count

O
PERATION
o Place the tubes into the tube holders. Be sure to follow the rules for balanced loads as listed in the next section.
o Close the lid and turn the lid knob clockwise to its complete stop position.
o The digital screen shows the currently selected cycle. To select another cycle, press the UP or DOWN button in
succession until the desired cycle is selected.
o Pushing the START button on the control panel will start the spin cycle.
o When the cycle is completed, the rotor will slow to a complete stop and the lid light will flash.
o The unlocking mechanism will engage for 60 seconds allowing entry into the rotor chamber. To unlock after more
than 60 seconds have elapsed, press the UNLOCK button. The lid will unlock for another 15 seconds.
o Turn the lid knob counterclockwise and open the lid. The lid light will turn off.
o You may now safely remove the samples.
Open Lid
With the lid open and the unit powered, press and hold the START
button. The cycle count will be displayed until the START button is
released.
| 9