Thrustmaster T500RS Manual De Instrucciones página 13

Adjusting the TRAVEL & resistance FORCE for the Brake pedal
CAUTION:
To adjust the TRAVEL and resistance FORCE for the Brake pedal, you must remove the
transparent plastic pinch-hazard protector (protecting the brake pedal), and install the
included metal stop. By doing so, you will no longer benefit from the intended protection
against pinch hazards.
To restore your protection against pinch hazards, you must remove the metal stop and
reinstall the transparent plastic pinch-hazard protector in its former location.
THRUSTMASTER® DISCLAIMS ALL RESPONSIBILITY FOR ANY INJURIES CAUSED BY
REMOVAL OF THE PINCH-HAZARD PROTECTOR OR INSTALLATION OF THE METAL STOP
- Unscrew the 2 screws holding the pinch-hazard protector on the brake pedal arm.
- Install the metal stop (23) at the rear of the brake pedal arm.
12/20