Thrustmaster T500RS Manual De Instrucciones página 251

Setting the Wheel's "SENSITIVITY" in "EMULATION" mode:
In these games, your wheel's steering has 2 sensitivity modes:
- "High Sensitivity" (default mode).
This mode is used to remove the steering axis's central dead zone (a zone which naturally exists on the
gamepad).
- "Normal Sensitivity" (requires setup).
This mode is used to keep the steering axis's central dead zone (a zone which naturally exists on the
gamepad).
Press the following buttons at the same time:
D-Pad + L3 + R3
Press the following buttons at the same time:
D-Pad + L3 + R3
Your wheel's steering is now more sensitive, especially in the center
- In these games, if the cursor moves on its own in the menus, enable the "Normal Sensitivity" mode to
solve this problem.
Setting the intensity of the "AUTOMATIC RETURN TO CENTER" in "EMULATION" mode:
In these games, your wheel automatically returns to the center.
You can adjust the intensity of this return to center (and so modify the steering's stiffness).
Press the following buttons at the same time:
MODE + L3 + R3
Press the following buttons at the same time:
MODE + L3 + R3
Setting "Normal Sensitivity" mode:
•
Action
Your wheel's steering is now in normal sensitivity
Setting "High Sensitivity" mode (default mode):
•
Action
"Low" Return to Center:
•
Action
"Normal" Return to Center (default mode):
•
Action
LOW RETURN TO CENTER:
(and wheel less hard to turn)
NORMAL RETURN TO CENTER:
(and wheel harder to turn)
10/22
LED status
BLINKS
LED status
DOES NOT BLINK
Result
Result