Bose RoomMatch RMS215 Instrucciones De Instalación Y De Seguridad página 9

pro.Bose.com
To attach RoomMatch side-plate array rigging kits to RoomMatch subwoofers, follow these steps:
®
1) Remove subwoofer from the shipping carton, remove packing materials, and place the subwoofer on the floor beneath planned
suspension point.
2) For the RMS215, remove the eight flat-head screws using a #3 square bit on the left and right sides of the subwoofer (four per side).
For the RMS218, remove twelve flat-head screws using a #3 square bit on the left and right sides of the subwoofer (six per side).
3) Insert M10 x 40 mm fasteners through individual side-plates and then into the subwoofer inserts, tightening by hand as shown in
Figure 1. Note the Left and Right part markings for side-plates. After both side-plates are attached, the subwoofer is ready for
integration with other RoomMatch modules in full-range arrays.
4) Attach the subwoofer/side-plate assembly to its associated array frame or upper subwoofer and tighten bolts by hand to facilitate align-
ment. After all bolts are in place, perform final tightening using torque not to exceed 35 to 40 foot-pounds (47 to 54 Newton-meters).
NOTE: U-shaped side-plate channel faces upward, the raised mounting bosses face the cabinet, and the oblong alignment slot at the
base of the side-plate points toward the front of the loudspeaker.
Figure 1. Attach side-plate with supplied bolts
5) For the RMS218 subwoofer, the side-plate array kit is designed to fit the RoomMatch Large Array Frame WITH the Short Extender
Bar installed in the "In" or "Out" position. The RMSFLY218 side plates are designed to attach to the Large Array Frame. Due to the
depth of the RMS218 subwoofer, additional support is required by attaching the included rear-strap plates to the rear side inserts.
See Figure 2. These rear-strap plates attach to the Array Frame Short Extender bars during array installation. For details, refer to the
document, RoomMatch Array Rigging Frames and Accessories Installation and Safety Guidelines.
Figure 2. RMS218 subwoofer with side plates and rear-strap plates installed
NOTE: When using the RMS215 or RMS218 subwoofer with other Bose
rary handles (which are included with each RoomMatch full-range array module) into each RMSFLY side-plate upper center hole to aid
in aligning subwoofer modules with array frames or other modules. The temporary handles may also be used to aid in lifting/moving the
RMS215 subwoofer, but should NOT be used to lift or move the RMS218 subwoofer. Remove the handles after positioning the sub-
woofer, before final tightening of bolts and elevating the array.
For additional information regarding the design and installation of RoomMatch arrays, please refer to the pro.Bose.com website to
download the document RoomMatch Array Design and Installation Guide, or use the Bose contact information in the back of this guide.
English
RoomMatch Array Module loudspeakers, thread the tempo-
® ®
Installation and Safety Guidelines
Installation
Page 9