Installing The Battery - Insignia IN-FR10111 Guia Del Usuario

IN-FR10111.book Page 4 Saturday, January 29, 2005 2:56 PM

Installing the battery

Your Insignia radio operates with either 4 AA alkaline batteries or a NiMH
battery pack (included). The belt clip should be removed (see below) to ease
installation or removal of the batteries.
To install the batteries:
1 With the back of the radio facing you, remove the belt clip (see diagram
on next page) for easy access, then remove the battery cover by
pressing down on the top center and sliding it down and away from the
radio.
2 Insert batteries oriented as shown in the diagram below and in the
diagram in the battery bay. Installing the batteries incorrectly will prevent
the radio from operating and may damage the radio.
3 Replace the battery cover by sliding it onto the radio.
4 Replace the belt clip, making sure it locks into place.
Insert one battery into
this slot
Battery
compartment
Press here and slide
down to open
Battery cover
4
www.Insignia-Products.com
IN-FR10111 GMRS/FRS Radio