Grundig Selio ECO Manual De Instrucciones página 123

13.2.2. Telephone
Problem
No display.
No dial tone.
Dial tone is OK, but can't
dial out.
Handset does not ring.
You experience
noise or fading in and out.
13.3.
Unit beeps
- Place handset in base for 20 seconds to reset the security code. If that doesn't work,
charge batteries for 15 hours.
- Clean charging contacts on handset and base with a soft cloth.
- See solutions for «No dial tone».
- Replace batteries.
13.4.
Memory dialling
- Did you program the memory location keys correctly?
- Did you follow proper dialling sequence?
- Make sure the tone/pulse setting is correct.
- Did you reprogram numbers into memory after power outage or batteries replacement.
Are batteries fully charged? Try replacing the
batteries.
Make sure the batteries are properly installed.
Check installation:
- Is the base power cord connected to a working
outlet?
- Is the telephone line cord connected to the base unit
and the wall jack?
Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial
tone in the second phone, the problem might be your
wiring or local service.
Is the handset out of range of the base?
Make sure the batteries are properly charged
(15 hours).
Are the batteries installed correctly?
Did the IN USE indicator come on?
The batteries may need to be charged.
Make sure the tone/pulse setting is correct.
Make sure the RINGER setting on the handset is
programmed to ON.
You may have too many extension phones on your
line. Try unplugging some phones.
See solutions for «NO dial tone».
Is handset out of range?
static,
Move closer to the base.
Does the base need to be relocated?
Charge batteries.
Make sure base is not plugged into an outlet with
another household appliance.
- 18 -
Solution
English