Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Console and Function Buttons
Console Front
Batteries Installation
Please install 2 pieces of AA 1.5V batteries in the battery case on the back of monitor.
NOTE: Whenever Batteries are removed, all the functions values will be reset to zero.
Auto On/Off
While the user starts to do exercise, the Display will show out the workout value automa-
tically. Once stop exercising over 256 sec, the Display will turn off. But the workout value
of odometer will be hold. While user starts exercise again, workout value of odometer will
accumulate continuously.
Auto Scan
After the monitor is power on or press Mode key, the LCD will display all functions values
from Time-Calories-Odometer- Pulse- Speed- Distance. Each value will be held for 6 se-
conds.
Speed
Display the current training speed from 0.0 to 99.9 KPH or MPH.
Computer
MODE
• Press the button to select TIME, DISTANCE and
CAL to preset.
• Press the button for selection function display
value on LCD, or enter after setting.
• Press the button and hold for 2 seconds to reset
all value except Odometer to be zero.
• (When the user replace batteries, all the values
will reset to ZERO automatically.)
SET
To set up the target value of TIME, DISTANCE and
CAL. Press the button and hold for 2 seconds to
speed up the increment.
RESET
• Press the button to reset function value when setting.
• Press the button and hold for 2 seconds to reset
all value except Odometer to be zero.
• (When the user replace batteries, all the values
will reset to ZERO automatically.)
Functions and Operation
21
Publicidad
Tabla de contenido
