Operation - Cub Cadet LS 25 CC Manual Del Operador

Operation

Starting & Stopping the Engine
Refer to the Engine Operator's manual packed with your log
splitter for instructions on starting and stopping the engine.
Using the Log Splitter
Operating Positions
1. Place the log splitter on flat, dry, solid ground.
2. Block the front and back of both wheels. See Figure 5-1.
Vertical
3. Place the beam in either the horizontal or vertical position
and lock into place.
NOTE: Take extra care when raising and lowering the beam
as it is heavy. Be sure to keep hands away from any possible
pinch points.
4. To place the beam in the vertical position proceed as follows:
WARNING!
vertical position when splitting heavy logs.
a. Pull the horizontal beam lock out to release the
beam and pivot the beam to the vertical position.
12
Horizontal
Figure 5-1
Always use the log splitter in the
b. To lock the beam in the vertical position, pull vertical
beam lock out and rotate it to secure the beam. See
Figure 5-2.
1
Vertical Beam Lock
Figure 5-2
5. To place the beam in the horizontal position proceed as
follows:
a. Pull the vertical beam lock out and rotate it down.
Pivot the beam to the horizontal position.
b. The horizontal beam lock is self-locking. The spring
loaded lock will snap into place when the beam is
lowered into position. See Figure 5-3.
2
Horizontal Beam Lock
Figure 5-3
5
2
1