Cub Cadet LS 25 CC Manual Del Operador página 19

Problem
Wood will not split or wood
splits too slowly
Leaking pump shaft seal
Wedge continues to move
when control handle is
released
Control handle does not
return to neutral when
released from forward
position
Cause
1. Small gear section damaged.
2. Pump check valve leaking.
3. Excessive pump inlet vacuum.
4. Incorrect oil level.
5. Contaminated oil.
6. Control valve leaking internally.
7. Overloaded cylinder.
8. Internally damaged cylinder.
1. Broken drive shaft.
2. Engine/pump misalignment.
3. Gear sections damaged.
4. Damaged shaft seal.
5. Plugged oil breather.
1. Damaged control valve
1. Hydraulic fluid too cold.
2. Hydraulic fluid too thick.
3. Hydraulic fluid contaminated.
4. Damaged control valve.
Remedy
1. See authorized service dealer.
2. See authorized service dealer.
3. Make certain pump inlet hoses are clear and
unblocked.
4. Check oil level.
5. Drain oil, clean reservoir and refill.
6. See authorized service dealer.
7. Do not attempt to split wood against the grain
8. See authorized service dealer.
1. See authorized service dealer.
2. Correct alignment as necessary.
3. See authorized service dealer.
4. See authorized service dealer.
5. Make certain reservoir is properly vented.
1. See authorized service dealer.
1. Warm up engine.
2. Replace hydraulic fluid.
3. Replace hydraulic fluid.
4. See authorized service dealer.
S 8 — t
ection roubleShooting
.
19