Troubleshooting - Hozelock Pico Power Manual De Instrucciones

• Disconnect the lance extension from the gun and
return to its storage position (fig 17).
• Return the gun to its storage position (fig 18).
• Remove the Inlet filter (fig 27) and return it to its
storage position on the side of the product (fig 19).
• Coil the high pressure hose taking care not to kink
it and store in its storage area at the back of the
product (fig 20).
• Engage the gun's red safety button (X).
Filling and using detergent
• Remove the detergent tank from its storage
location (fig 21).
• Remove the nozzle by twisting and pulling upwards
(fig 22).
• Fill the tank with highly degradable detergent mixed
with water as recommended on the detergent's
directions (fig 23) and refit the nozzle (fig 24).
• Attach the detergent tank to the lance extension (F)
by pushing in and twisting until it stops (fig 25).
Using detergent feature
• Maximum cleaning is achieved by applying the
detergent mixed with water to the surface while still
dry. When dealing with vertical surfaces work from
the bottom upwards. Leave the detergent to act
for 1-2 minutes but do not allow the surface to dry.
Starting from the bottom, use the high pressure jet
at a minimum distance of 30cm. Do not allow the
rinse water to run onto unwashed surfaces.
• After use, return the detergent tank to its storage
location (fig 21).
Maintenance
Any maintenance operations not covered by this
chapter should be carried out by an authorised
service centre.
Caution - Danger ! Always disconnect the plug
from the power socket before carrying out any
work on the appliance.
Cleaning the nozzle
• Disconnect the nozzle from the lance extension (fig
15).
• Remove any dirt deposits from the nozzle hole using
the tool (L) as shown in fig 26
Cleaning the filter
• Inspect the inlet filter (I) before each use and clean
if necessary as shown in figs 27 & 28. The cleaning
interval required will vary on the hardness of your
water so you should inspect the filter regularly.
End-of-season storage
• Ensure there is no residual water left in the
appliance and protect against frost.

Troubleshooting

Problem
Causes
Possible
Pump does Nozzle
not reach worn.
working
Water filter
pressure.
blocked.
Water
Supply
pressure
low.
Air being
sucked into
product.
Air in pump. Switch off the appliance
Adjustable
nozzle not
Positioned
correctly.
Pressure Water
drops intake from
during use. external
tank.
Intake
water too
hot.
Nozzle
clogged.
Motor Insufficient
'sounds' but power
fails to supply.
Start.
Voltage loss
due to use
of
extension
cable.
Remedy
Replace nozzle
Clean filter (figs 27 & 28).
Turn on water supply tap
fully.
Check tightness of
hose fittings.
and keep de-pressing
and releasing the gun
trigger until the water
comes out in a steady
flow. Switch the
appliance back on again.
Turn the adjustable
nozzle (+) (fig 12).
Connect appliance to
the mains water supply.
Reduce temperature.
Clean nozzle (fig 26).
Check that the voltage
of the mains power
supply line is the same
as that on the rating
plate (fig 8).
Check characteristics of
extension cable.
9