Cedar Ridge CRHLD18TB Manual Del Usaurio página 19

4. Insert pins on the back of log #4 into slots
in front log bracket on heater base, and
tighten nuts (see Figure 21).
5. Insert the recessed hole on the bottom of
log #5 onto pin on log #1, with the other
end placed on log #4 (see Figure 22).
Log #4
Figure 21 - Installing Logs #3 and #4
1. Insert log #1 into slots in rear log bracket
on heater base, and tighten nuts (see
Figure 23).
2. Insert log #2 and log #3 into slots in middle
log bracket on heater base, and tighten
nuts (see Figure 23).
3. Insert log #4 and log #5 into slots in front
log bracket on heater base, and tighten
nuts (see Figure 24).
4. Insert the pin on the bottom of log #6 onto
the recessed hole on log #2 with the other
end placed on log #1 (see Figure 25).
5. Insert the pin on the bottom of log #7 onto
the recessed hole on log #2 with the other
end placed on log #5 (see Figure 25).
Log #2
Figure 23 - Installing Logs #1, #2 and #3
200028-01A
INSTALLATION
Log #3
Model CRHLD24TB (24" Log Set)
Log #1
Log #3
www.usaprocom.com
6. Insert the recessed hole on the bottom of
log #6 onto pin on log #1, with the other
end placed on log #3 (see Figure 22).
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Log #5
Figure 22 - Installing Logs #5 & #6
6. Insert the pin on the bottom of log #8 onto
the recessed hole on log #5 with the other
end placed on log #1 (see Figure 25).
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Log #4
Figure 24 - Installing Logs #4 and #5
Log #7
Log #6
Figure 25 - Installing Logs #6, #7 and #8
Log #6
Log #5
Log #8
19