Locating Heater; Battery Instructions - Cedar Ridge MD3TPF Manual Del Usaurio

This heater is designed to be mounted on a
wall. For convenience and efficiency, install
heater:
INSTALLING THERMOSTAT SENSING BULB (OPTIONAL)
1. Pull out the sensing bulb from the two clips
located in the shipping position. There is
no need to take out the two bulb clips.
2. Take out the bulb clip from the hardware
package and insert it into the square hole.
Then insert the sensing bulb into the bulb
clip (see Figure 4).
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For long periods of non-operation, remove
batteries from all components for safety.
Mounting Bracket
The mounting bracket is located on back panel
of heater (see Figure 6). It has been taped
there for shipping. Remove mounting bracket
from back panel.
200033-01B
INSTALLATION

LOCATING HEATER

BATTERY INSTRUCTIONS

FASTENING HEATER TO WALL
www.usaprocom.com
1. Where there is easy access for operation,
inspection, and service.
2. In the coldest part of room.
Figure 4 - Moving Thermostat Sensing
Unscrew ignitor cap and install a AAA battery
with the + pointing out. Replace cap.
AAA
Battery
Positive
UP
Figure 5 - Installing Battery in Ignitor
Mounting Bracket
Figure 6 - Mounting Bracket Location
Bulb
11