Jump-Starting - Würth SHG 12-700 Guia De Inicio Rapido

OBJ_BUCH-0000000118-001.book Page 9 Thursday, March 14, 2013 11:55 AM
Tool Specifications
Booster 12V
Article number
Voltage
Capacity
Peak current
I-start
Charge capacity
Charging voltage at 25 °C
Cross section of copper cable
Cable length, red/black
Insulated terminal clamp
Circuit protection to cigarette
lighter
Power rating display
with line switch
Voltage peaks, protected
Venting of battery gas
Emergency venting
Short-circuit capability
Automatic charger
Weight
Protection class
Operation
The internal battery of the
BOOSTER must always be fully
charged and should never be com-
pletely discharged. Use the
BOOSTER only when at least one
LED lights up; otherwise, there is a
risk of deep discharging and dam-
age.

Jump-starting

With the BOOSTER switched off, firstly connect the red
clamp to the positive terminal of the battery.
Afterwards, connect the black clamp to the chassis
frame or the engine block. Ensure sufficient clearance
to the battery and the fuel lines.
Voltage Retention
The voltage-retention feature ensures that stored data
of your vehicle (e. g. the radio code) are retained dur-
SHG 12-700
ing the charging with the BOOSTER. Plug one end of
0772 870
the provided charge cable into the BOOSTER socket
12 V
and the other end into the cigarette lighter.
16 Ah
The green LED on the cigarette lighter should be lit.
1800 A
Charging
700 A
 Provide for a high charge condition of the
5.5 A
BOOSTER!
15 V
The charge-condition indication consists of 5 LEDs. To
2
35 mm
indicate the charge condition, press the red battery test
0.6 m
button. The BOOSTER is fully charged when all 5 LEDs
Metal
light up (2 x red, 1 x yellow and 2 x green).
When only 3 LEDs light up, immediately charge the
16 A
BOOSTER for several hours.
5 LEDs
Charging options:
•
• With the provided automatic charger
•
• With the charge cable via the vehicle's cigarette
•
lighter
•
• Power consumed during the engine start can be
380 – 2000 A
regenerated by leaving the BOOSTER connected
to the running engine for 2 – 3 minutes after the
1.5 A
starting
9.0 kg
Please observe to recharge the BOOSTER (min.
III
12 hours) each time after using and to keep the charge
condition high (if required, through continuous charg-
ing). Remove the Booster from the power supply only
when using it.
Charger
Only use the provided automatic charger or the charge
cable for charging via the car. In this case, the vehicle
regulator automatically regulates the charging.
During the charging, the red LED on the charger lights
up. The illumination of the LED gradually becomes
weaker, but never goes out completely, as the device
is equipped with a trickle-charge function.
9