Installation - Fondital 0KITSAMB00 Instalación Uso Y Mantenimiento

2.

INSTALLATION

Installation must be carried out exclusively by skilled personnel.
1) Determine where to install the ambient
probe. The cable connecting the probe to the
boiler can be maximum 100m long
2) Power the boiler off
3) Drill a hole cover by means of a diameter 8
drill;
4) Fit the probe holder securing it with the
supplied nut and ensure that holes are at right
angles with floor
5) Drive the probe and the relevant seal fully
home into probe holder hole. Check the holes
to ensure that the probe is fully home. Fit the
insulator on the back of support, with the
aluminised side facing inwards. The insulator
and the O-ring prevent the wall temperature
from interfering with the probe
6) Fit the assembled module on support
17