Marinco SPL-12W Instrucciones página 3

spotlight (containing the securing screw hole)
while depressing the gasket on the front side of the
spotlight (opposite the securing screw hole). Insert
securing screw and ensure that it is fully
engaged and secure.
WARNING
! YOU MUST FEEL THE SCREW REACH
A TWISTING TORQUE TO KNOW THAT IT IS
PROPERLY ENGAGED
Note: In the photograph, the purple and yellow control
wires are shown for the wired-remote. If a wireless bridge remote is used, then the purple
and yellow leads are not necessary and can be tucked away within the spotlight base
Mounting the wired and wireless bridge remote
1. The remotes are all IP54 weather resistant.
2. Please choose a mounting location based on the gasket supplied with the remote (large
hole should be towards top)
3. Drill holes the correct size for the mounting screws. The holes through the remotes are
sized for a No. 6 pan head screw. The length and thread type will need to be determined
by the application. Remove and set aside the 2 screw covers.
4. Drill hole for the wiring. Note that the hole needs to be 5/8" to allow the unit to sit flat.
5. If mounting the wireless bridge remote it will require a 12V or 24V power source.
If mounting the hard wired bridge remote then it does not need a local power source
and instead uses the purple and yellow wires connecting from the spotlight to the
remote. These two wires will supply the remote with power and control the spotlight. The
terminals on the remote can handle a 16 AWG to 26 AWG wire. Maximum torque on the
terminals is 2.21 in lbs (.25 nm).
6. Feed wires through drilled surface hole and gasket from below.
7. For the wireless bridge remote attach the power source wires to the remote (+) positive
and (-) negative terminals. For the hard wired bridge remote attach the 2 wires from the
spotlight. The yellow wire needs to connect to the (+) positive and the purple wire needs to
connect to the (–) negative. Maximum torque on the terminals is 2.21 in lbs (.25 nm)
8. Place remote in desired location, align holes and tighten down.
9. Apply screw covers to remote to hide screws.
Pairing of wireless bridge and hand held wireless remote to spotlight
1. Disconnect all power to the spotlight.
2. Apply power to wireless remote. Press and hold the power button on the wireless remote.
3. While pressing the power button connect power to the spotlight.
4. After a few seconds you will hear the relay click and the light will turn on.
5. When the light turns on the paring is complete, release power button.
Paring multiple spotlights with separate remotes
If multiple spotlights will be within 200' of one another and you want to control each spotlight
with independent remotes, please follow the instructions below.
1. For 1st spotlight, follow the "Pairing of wireless bridge and hand held wireless remote to
spotlight" instructions above.
2. For 2nd spotlight, follow instructions above except press and hold the power button AND
the UP button while inserting the battery in an SPLR-1 remote or connecting power to an
SPLR-2 remote.
3. For 3rd spotlight, follow instructions above except press and hold the power button AND
the RIGHT button while inserting the battery in an SPLR-1 remote or connecting power to
an SPLR-2 remote.
Precision Spotlight Instructions
3