Marinco SPL-12W Instrucciones página 5

BULB REPLACEMENT CAUTION! AVOID
TOUCHING THE GLASS SURFACE OF
THE NEW BULB. (TOOLS REQUIRED:
MEDIUM PHILLIPS SCREWDRIVER AND
SMALL FLATHEAD SCREWDRIVER)
1. Remove 2 screws on bottom of lens
bezel.
2. Remove the bezel by inserting a small
flathead screwdriver into the two
locations circled. Gently separate the
bezel from the body at both locations
using a straight separating motion until
you feel the bezel release from the lens.
3. Remove 6 screws from around the lens.
Precision Spotlight Instructions
4. Remove lens and reflector as an
assembly.
5. Remove the screw holding the metal
grounding bar behind the reflector.
Remove the bulb assembly by pushing
on the bulb so it exits the back of the
reflector.
6. Unplug bulb and replace with new bulb.
(or 24 volt bulb if installation requires).
DO NOT TOUCH THE GLASS
SURFACE OF THE BULB. During
reassembly, hand tighten all screws until
snug. Do not overtighten or use a power
driver as doing so may strip the threaded
screw bosses.
5