Marinco SPL-12W Instrucciones página 4

Precision Spotlight Instructions
4. For 4th spotlight, follow instructions above except press and hold the power button AND
the DOWN button while inserting the battery in an SPLR-1 remote or connecting power
to an SPLR-2 remote.
5. For 5th spotlight, follow instructions above except press and hold the power button AND
the LEFT button while inserting the battery in an SPLR-1 remote or connecting power to
an SPLR-2 remote.
Programming the remote when mounting the spotlight upside down
NOTE: This procedure reverses the directional buttons on the remote.
1. Pairing of the remote described above must be completed first.
2. Disconnect all power to the spotlight.
3. Hold down the tilt UP and DOWN buttons on the remote.
4. While pressing the 2 buttons apply power to the spotlight and continue to hold down the
buttons for a few seconds until the spotlight tilts up or down.
5. The spotlight is now configured for inverted mode. Release buttons.
6. To return the spotlight to the standard configuration repeat steps above.
WARNING BEFORE OPERATION REMOVE BLUE FILM FROM LENS
!
Operation
SOS
(· · · — — — · · ·)
Pressing this button the light will begin
to signal the Morse code distress signal.
Press again to turn off.
Power on/off
Speed Control
Pressing this button will allow
you to change speed of the light,
SOS, and Sweep Angle function.
Auto Sweep
When this button is pressed
the light will begin to sweep left
and right at 90° for slow speed
and 70° for high speed. Press
the button again or a directional
button to stop the sweep.
4