Worx LANDROID M Guia De Instalacion página 6

Installation
Pegging your boundary wire
We recommend that you first mow the lawn where the wire is to be laid using a normal lawn mower or a
grass trimmer. This ensures that the wire is laid as close to the ground as possible so the Landroid
accidentally cut the wire. The boundary wire is powered with a very low voltage so that it is totally safe to human
beings and pets.
10
EN
® M does not
1
Place the Charging Base in its designated spot, without fixing it
permanently. The "IN" arrow should be oriented so that it indicates
the inside of your lawn.
2
Feed the boundary wire through the tunnel underneath the
charging base.
3
Leaving about 1 meter in length of extra wire, start from the
rear of your charging base and begin pegging the wire along
the boundary. When you've finished laying the wire along the
boundary back to the charging base, leave another meter of
extra wire and then cut it.
4
When laying the boundary wire,
use the distance gauge to keep a
35cm* space between the wire
and the boundary. However, in
the case of an obstacle that is
level with ground and safe for the
Landroid M to run over, such as a
®
driveway or sidewalk, then only a
10cm* space is needed.
Each wire peg should be placed
around 80cm apart
Knock the wire pegs tight to
the ground with the help of the
hammer, although avoid putting
too much pressure on the wire.
Keep the boundary wire straight
and tight between the pegs, there
should not be any slack wire.
* This is the recommended
distance. Use the provided
distance gauge to ensure proper
installation.
5
Ensure the Boundary Wire is perfectly straight in each corner.
6
When making an island with the boundary wire, follow the path as
shown. The wire should run from the perimeter to outline the defined
island and then return back to the perimeter. The boundary wire in
between the island and perimeter should be laid close together
and held in place by the same wire peg. During operation, the
Landroid M will be able to freely pass over this part of the wire.
®
11
EN